We do recommend that you change the factory program code (0000) to a secure code which you must make note of. Failing to make note of your new program code will prevent you from being able to add or delete pin codes in the future. You would then be required to perform the ‘Keypad reset’.

Factory pin code in the keypad to start off with is 1111#. When entering in your first pin code the factory pin code will be wiped.

Pairing the receiver to the wireless keypad

You must have a 4digit pin number setup in your keypad before pairing

1. With the power connected to the receiver, make sure one black jumper link is over the RELAY pins (if this is not already set).
2. Enter your 4 digit pin code = ? ? ? ? # (you only have a few seconds to pair the 2 together). Wait for the green light on the receiver to flash quickly then place the 2nd black jumper link over the REMOTE pins for 2 seconds (only) and then remove the black jumper link. Now test that the keypad works.
3. When finished, make sure to place the 2nd black jumper back on 1 pin only.

Changing the 4 digit ‘program code’ (0000)

1. Enter program code (factory 0000) then press *
2. Press 6 9 #
3. Enter new 4 digit program mode code #

Deleting keypad from recevier

Note: deleting an accessory from this receiver will delete all accessories tuned in. You will be required to tune any other items back in that you still require.

1. With the power connected to the receiver, place a link over the ERASE pins.
2. The LED will flash ten times and then remain on solid.
3. Remove the link. The keypad and all other accessories tuned the receiver have now been erased.

Setting up a 4 digit pin code in your keypad

1. Enter program code (factory 0000) then press *
2. Press 0 1 #
3. Enter your pin code = ? ? ? ? # (pin code now entered)

Turn off/on keypad backlight

1. Enter program code (factory 0000) then press *
2. Press 3 9 #

Delete a single pin code from the keypad

1. Enter program code (factory 0000) then press *
2. Press 5 8 #
3. Enter 4 digit pin number that you want to delete (keypad will give 1 long beep followed by a short beep to indicate the pin code deleted)

Erasing all pin codes from the keypad

1. Enter your program code (Factory is 0000) then press *
2. Press 0 0 #
3. Now all pin codes will be wiped and set back to the factory pin code 1111#

Battery test

1. Enter program code (factory 0000) then press *
2. Press 8 9 # (battery is OK with a long beep or if battery is low there will be a short beep and the red LED indicator will show)