We do recommend that you change the factory program code (0000) to a secure code which you must make note of. Failing to make note of your new program code will prevent you from being able to add or delete pin codes in the future. You would then be required to perform the ‘Keypad reset’.

Factory pin code in the keypad to start off with is 1111#. When entering in your first pin code the factory pin code will be wiped.

Pairing the receiver to the wireless keypad

You must have a 4digit pin number setup in your keypad before pairing

1. Press P1 on the receiver board (red LED will go solid)
2. Enter your pin code = ? ? ? ? # (red LED will flash to say keypad and receiver are paired)

Changing the 4 digit ‘program code’ (0000)

1. Enter program code = 0 0 0 0 *
2. Press 6 9 #
3. Enter new 4 digit program mode code #

Deleting KP recevier memory

• Press P2 on the receiver board for 8 seconds (red LED will go solid, keypad and receiver now unpaired)

Setting up a 4 digit pin code in your keypad

1. Enter program code (factory 0000) then press *
2. Press 0 1 #
3. Enter your pin code = ? ? ? ? # (pin code now entered)

Delete a single pin code from the keypad

1. Enter program code (factory 0000) then press *
2. Press 5 8 #
3. Enter 4 digit pin number that you want to delete (keypad will give 1 long beep followed by a short beep to indicate the pin code deleted)

Turn off/on keypad backlight

1. Enter program code (factory 0000) then press *
2. Press 3 9 #

Erasing all pin codes from the keypad

1. Enter your program code (Factory is 0000) then press *
2. Press 0 0 #
3. Now all pin codes will be wiped and set back to the factory pin code 1111#

Battery test

1. Enter program code (factory 0000) then press *
2. Press 8 9 # (battery is OK with a long beep or if battery is low there will be a short beep and the red LED indicator will show)